
12
12-4 z.one ultra and z.one ultra sp OPERATOR MANUAL
The following section assumes that the Sony UP-D897 B&W USB Printer has
already been mounted on the
SmartCart/SmartCart sp and properly connected to
the System.
■
For information on installation/hook-up, see the Proc, Installation, Sony
UP-D897 B&W USB Printer (ZONARE P/N: S00075-00) document provided
in the installation kit shipped from ZONARE with each printer. This information
is also provided in the z.one ultra Service Manual.
■
For detailed information on proper operation of this device, see the SONY
UP-D897 Operators Manual.
To Operate
1. Power on the SmartCart/SmartCart sp and allow it to fully boot.
2. Open the front door of the unit and install the film pack.
3. Power on the printer by pressing the ON button on the printer’s front panel.
4. Acquire the desired ultrasound image on the system.
5. Press the Freeze button.
6. Depending on the Store/Print button configuration, press the appropriate
button (Store1, Store2, or Print on the
SmartCart/SmartCart sp) to trigger a
print of the current onscreen image to the Sony UP-D897 printer.
NOTE: If the Print/Store configuration is set up in Exam Completed mode (see “To
Configure Image Transfer Mode” on page 13-20), it will be necessary to press End
Exam before the printed image(s) will be placed in the print queue and sent to the
printer.
Sony UP-D25MD Digital (USB) Color Printer
Figure 12-4. Sony UP-D25MD Digital (USB 2.0) Color Printer
■
For information on installing and configuring this printer, see the Procedure,
Install (Unmounted), SONY UP-D25MD Color Printer (ZONARE P/N:
S00119A) document provided in the installation kit shipped from ZONARE with
each printer. This information is also provided in the z.one ultra Service
Manual.
■
For detailed information on proper operation of this device, see the SONY
UP-D25MD Operators Manual.
Komentáře k této Příručce