Quatech Audio/Video Capture USB 2.0 Specifikace stáhnout pdf (Strana 321)

z.one ultra and z.one ultra sp OPERATOR MANUAL 13-3



Wireless Network Connectivity

ZONARE supports wireless connectivity using the Quatech AirborneDirect

Wireless Ethernet Bridge (supported model is the ABDG-ET-DP501-1). This is a

plug-and-play wireless networking solution that is compatible with all ZONARE

ultrasound systems that support Ethernet connectivity. A special power cable,

however, is required to supply power to the Quatech AirborneDirect device from

the ZONARE system USB bus for portable operations.

The Quatech AirborneDirect Wireless Ethernet Bridge works with all ZONARE

software release revisions; however the 3.5 and subsequent software releases

have specific enhancements to provide user feedback for signal strength and

wireless connectivity.

The Quatech AirborneDirect Wireless Ethernet Bridge supports WiFi 802.11b/g

wireless standards and connects to the ZONARE system through a 10 Base-T

network interface. This device supports WEP (64/128 bit) and WPA encryption

standards, and LEAP for network authentication (LEAP required the Quatech

device to be configured with a static 128 bit key; this is known as “migration mode”

and is not recommended for longterm use due to the static WEP key

requirement).

Before using it with the ZONARE system, the Quatech AirborneDirect device must

be preconfigured for the user's networking environment – SSID, channel,

encryption, and correct addressing scheme (DHCP/static).

Static IP addressing is required in order to be able to display the additional

wireless status available in the 3.5 and subsequent releases.

When power is applied to a correctly configured Quatech AirborneDirect device

that is connected to the Ethernet port on the ZONARE system, it will require 30 to

60 seconds to detect and then associate with the user's wireless network. Once a

wireless network connection is established, the ZONARE system will reflect the

connection state by showing the network icon in an uncrossed state (see

Figure 13-7 on page 13-6).

In the 3.5 and later software releases, the user can obtain additional wireless

network status by configuring the Wireless Bridge section of the Network

Configuration screen (

Figure 13-1). The information required is the static IP

Address assigned to the Quatech AirborneDirect device and the Username and

Password for the CLI interface (default is dpac for both).

To set up wireless network communication, contact Technical Support (see

“ZONARE Contact Information” on page 15-1).

Storage Media

For information on configuring the Storage Media screen, see page 11-2.

1 2 ... 316 317 318 319 320 321 322 323 324 325 326 ... 403 404

Žádné komentáře

Quatech Audio/Video Capture USB 2.0 Specifikace Strana 321