Quatech Audio/Video Capture USB 2.0 Specifikace stáhnout pdf (Strana 360)

14-18 z.one ultra and z.one ultra sp OPERATOR MANUAL

3. Press the Power button on the Scan Engine, and then immediately make note

of the battery charge LED indicators (located on the lower left side of the

Scan

Engine

; see Figure 4-4 on page 4-5). All four battery LED indicators are lit

when the battery is fully charged. The four LED indicators are illuminated in

25% increments:

• 4 LEDs = 76-100% charge

• 3 LEDs = 51-75% charge

• 2 LEDs = 26-50% charge

• 1 LED = 0-25% charge

4. If you are certain the battery is fully charged (as described above) and the

Scan Engine does not perform accordingly, replace the battery or contact

ZONARE Technical Support for assistance. There are no user remedies for

battery insufficiency problems other than maintaining a full charge.

Battery

Charging

(Scan Engine)

For optimum performance, the battery packs should be maintained in a charged

state. Battery charging occurs when the

SmartCart/SmartCart sp is connected to

an active power receptacle, the battery pack is inserted into the

Scan Engine, and

the

Scan Engine is stored in a docked condition on the SmartCart/SmartCart sp.

Remote charging and recalibrating (resetting of the charge fuel gauge) of the

battery pack is done using the ZONARE 2-Bay Battery Charger unit (Part # Z311:

for 110V or #Z312: for 220V).

Battery

Maintenance

(Scan Engine)

The battery is a spill-proof maintenance-free sealed battery. There are no user

actions for battery maintenance other than maintaining a charged state.

Typical battery life is one to two years when the battery is maintained in a charged

state. Leaving the battery in an uncharged state reduces its life. Using the Zonare

2-Bay Battery Charger’s “Recalibrate” (recondition) cycle on a scheduled basis

will help maintain optimum efficiency and performance of the batteries.

CAUTION: If the SmartCart/SmartCart sp will be stored in a location where power

cannot be supplied (to maintain the battery in a charged state) for more than five

days, the battery should be removed from the

Scan Engine to help prevent

potentially hazardous conditions as a result of the battery deteriorating.

WARNING: To protect the Scan Engine battery from potential thermal damage,

the System monitors the temperature of the battery at all times. If the battery is

detected as exceeding the maximum safe operating temperature, a warning

message will appear on the

SmartCart/SmartCart sp display.

NOTE: The Operator should immediately complete all active operations in

preparation for the System automatically initiating a power-down sequence.

Internal

Storage Media

Maintenance

The Scan Engine internal storage media should not be used for long-term storage

of studies and patient information. Studies should be deleted from the storage

media on a regular basis (daily or weekly) as part of normal User maintenance on

the

Scan Engine.

1 2 ... 355 356 357 358 359 360 361 362 363 364 365 ... 403 404

Komentáře k této Příručce

Žádné komentáře

Quatech Audio/Video Capture USB 2.0 Specifikace Strana 360

Komentáře k této Příručce